RR starting probs,

Welcome to the...

Message Board for Plymouth Roadunner Owners & Enthusiasts (including Superbirds and GTX)
Fellow B-Body Satellite and Charger and F-Body owners also welcome

Plymouth Roadrunner Owners Group > Restoration > RR starting probs,
	<< Prev Topic \| Next Topic >>

Author	Comment
rrroger Coyote Duster Posts: 31 (2/23/02 3:51 pm) Reply	RR starting probs, A while back I posted a question as to why the bird would not fire until the key came back to the "On" position. I received a lot of very good input as I was trying to avoid tearing into the steering column. I have replaced the ballast resistor and watched the volt meter fall to Zero on IGN #1 when I turn the key to start. It starts fine when I use the remote starter on the relay. Yesterday, I applied pressure to each of the three connectors on the fire wall, and did the same thing from inside. Checked the clutch switch, everything OK there. Tried the key "BAM" Fired right up! Today, started fine in the shop. I go to the store, tried to start it, just cranked, pulled out the trusty remote and it started. It's the original harness routed correctly (completely disasembled dash during resto), it has started fine for a couple years. What can I do to better secure the connectors?

<< Prev Topic | Next Topic >>

Email This To a Friend
Topic Control Image

Topic Commands

Click to receive email notification of replies

Click to stop receiving email notification of replies

- Plymouth Roadrunner Owners Group - Restoration -

Plymouth, Superbird, Charger, and Volare are registered trademarks of DaimlerChrysler.
Roadrunner and the Roadrunner image are registered trademarks of Warner Brothers.
The Plymouth Roadrunner Owners Group is in no way affiliated or associated with DaimlerChrysler or Warner Brothers and/or thier holding companies.

Powered By ezboard® Ver. 7.32
Copyright ©1999-2007 ezboard, Inc.