RoadRunner Starters

Welcome to the...

Message Board for Plymouth Roadunner Owners & Enthusiasts (including Superbirds and GTX)
Fellow B-Body Satellite and Charger and F-Body owners also welcome

Plymouth Roadrunner Owners Group > Roadrunner Questions > RoadRunner Starters
	<< Prev Topic \| Next Topic >>

Author	Comment
roadrage28 New Beeper Posts: 2 (5/30/03 9:32 pm) Reply	RoadRunner Starters I am trying to replace my starter on my '69 RR. It has a 383 with a 4-speed. I bought a new one at AutoZone. I installed it but the tail end of the starter is not fitting in the hole in the bellhousing so the pinion is not lining up and engaging the flywheel. Is it possible that my bell housing is for a 440? Should I use a rubber mallet and knock the starter into the whole? The old starter has a lot of wear on tail where it was rubbing against the bell housing. I am also missing a bolt on the bottom corner of the bellhousing which may be adding to the vibration. When I bought this car the flywheel used to grind a little when starting.

<< Prev Topic | Next Topic >>

Email This To a Friend
Topic Control Image

Topic Commands

Click to receive email notification of replies

Click to stop receiving email notification of replies

- Plymouth Roadrunner Owners Group - Roadrunner Questions -

Plymouth, Superbird, Charger, and Volare are registered trademarks of DaimlerChrysler.
Roadrunner and the Roadrunner image are registered trademarks of Warner Brothers.
The Plymouth Roadrunner Owners Group is in no way affiliated or associated with DaimlerChrysler or Warner Brothers and/or thier holding companies.

Powered By ezboard® Ver. 7.32
Copyright ©1999-2007 ezboard, Inc.